Mytee CRB3010 Carpet Shark parts

Revision not recorded. Serial range not recorded.

• Confirm model CRB3010, 10-inch brush length, tile-and-grout surface and chemical compatibility, shaft and drive-end geometry, rotation pairing, and two-brush quantity before ordering.

Revision not recorded. Serial range not recorded.

• Confirm model CRB3010, 10-inch brush length, soft plush-carpet application, shaft and drive-end geometry, rotation pairing, and two-brush quantity before ordering.

Revision not recorded. Serial range not recorded.

• Confirm model CRB3010, 10-inch brush length, stiff low-pile or CGD application, shaft and drive-end geometry, rotation pairing, and two-brush quantity before ordering.

Revision not recorded. Serial range not recorded.

• Confirm 115-volt CRB3010, 90-VDC motor, rectifier and control system, 6.7:1 ratio, 88 mm diameter, shaft, mounting, rotation, connector, and revision before ordering.

Revision not recorded. Serial range not recorded.

• Confirm model CRB3010 and the 10-inch machine width.

Revision not recorded. Serial range not recorded.

• Confirm model CRB3010 and compare the plate orientation.

Revision not recorded. Serial range not recorded.

• Confirm model CRB3010, 10-inch machine size, and shaft geometry.

Revision not recorded. Serial range not recorded.

• Confirm model CRB3010 and that the left side plate is required.

Revision not recorded. Serial range not recorded.

• Confirm model CRB3010 and compare the bearing-side geometry.

Revision not recorded. Serial range not recorded.

• Confirm model CRB3010, 10-inch machine size, and support mounting points.

Revision not recorded. Serial range not recorded.

• Confirm model CRB3010 and compare the handle pivot geometry.

Revision not recorded. Serial range not recorded.

• Confirm model CRB3010 and that the complete five-piece handle assembly is required.

Revision not recorded. Serial range not recorded.

• Confirm model CRB3010 and the 10-inch machine width.

Revision not recorded. Serial range not recorded.

• Confirm model CRB3010, 10-inch machine size, and handle-base mounting pattern.

Revision not recorded. Serial range not recorded.

• Confirm model CRB3010, 10-inch machine size, and required brush position.

Revision not recorded. Serial range not recorded.

• Confirm model CRB3010, 15 mm width, 380 mm length, and 76 teeth.

Revision not recorded. Serial range not recorded.

• Confirm model CRB3010, required side, and mounting points.

Revision not recorded. Serial range not recorded.

• Confirm model CRB3010 and the 10-inch machine size.